Archery Addix banner

1 - 6 of 6 Posts

·
Registered
Joined
·
6 Posts
Discussion Starter · #1 ·
hey all, my pro shop installed some moleskin around the rest and up the riser and I wanted to know if there's a safe way to remove the adhesive material without damaging the finish?

thanks.
 

·
Registered
Joined
·
680 Posts
try goo gone. Id avoid goof off at first due to it having toluene.
goo gone is an orange oil smelling cleaner.

if that doesnt work, try rubbing alcohol then mineral spirits on a qtip on a small area. if you see the glue on the qtip use that solvent.

if those two dont work then youll need to try goof off or acetone (finger nail polish remover) go light and be careful
 
G

·
asylum said:
i use alcohol...you need to rub it a little longer but i havent had any problems with the bow finish coming off
DITTO....rubbing alcohol, just removed some last night and layed down new camo moleskin.
 

·
Registered
Joined
·
210 Posts
WD40 also works great for stuff like this, but I'm not sure how the dipped finish might react to something like that... It *SHOULD* be ok, but.... ***disclaimer*** test in an inconspicous area first.

Otherwise, a pencil eraser might actually work too...
 
1 - 6 of 6 Posts
Top